Shake the bottle.
Apply to the desired area by pressing the nib on the bed (activating the inner valve) and spreading as needed.
Print according to the filament/printer manufacturers recommendations.
Allow to cool and Remove. The print should pop right off
Clean - Use a damp cloth to wipe off.
SAFETY:Using this product with other than PEEK filaments might cause over adhesion and damage your build surface. Follow the instructions found in the technical data sheet for best results.Tips:For larger prints a 20 mm brim is recommendedMagigoo HT was designed for glass surface but also works on high temperature garolite and other build-surfaces
Important note : The applicator has an active spring valve, which activates when applicator is pressed against the build plate. Please do not press the bottle as "ketchup bottle" , otherwise the applicator may pop off. Bottle may be slightly squeezed, only when the nib is pressed against the bed and it may be necessary only if bigger flow is required. Bottle must not be squeezed when cap is off any other time as it may result in glue popping out of the bottle.
Material Database / Print Settings
There are no reviews yet.
Please see our Privacy Policy
